Flickering or dimming lights
One fixture: usually the bulb or the dimmer. LED bulbs on an older dimmer that wasn’t made for them flicker, and a bulb that’s not screwed in all the way does the same.
One room or one circuit: a loose connection at a switch or outlet on that circuit. Push-in (“back-stab”) connections on receptacles loosen with age and heat; we find the one that’s arcing and re-terminate it.
The whole house, especially lights that dip when the AC or dryer kicks on, or go bright in one room and dim in another: that points at the service itself, a loose connection at the meter, the panel or the utility’s neutral. That one deserves a visit soon.
Try first: swap the bulb, check the dimmer is rated for LED. Call us if: it’s more than one fixture, it’s new, or you hear buzzing with it.
Breaker keeps tripping
Trips the instant you reset it: a short or a ground fault somewhere on the circuit, often inside a device, a cord or a box. Leave it off.
Trips after a while, under load: the circuit is overloaded (space heater, hair dryer, microwave and toaster on the same kitchen circuit) or an appliance is failing and drawing too much.
AFCI or GFCI breaker: these trip on tiny faults a standard breaker ignores, and some appliances set them off. Sometimes it’s a real fault; sometimes the breaker or the device needs to change. We test to tell which. Breakers also simply wear out, and a breaker that’s warm to the touch is telling you something.
Try first: unplug everything on the circuit, reset it once (push fully OFF, then ON). Call us if: it trips again with nothing plugged in, trips right away, or the breaker is warm.
Dead outlets
Check for a tripped GFCI first. One GFCI in a bathroom, the kitchen, the garage or outside often protects a string of ordinary-looking outlets downstream, sometimes in a different room. Press RESET on every GFCI you can find.
Then the panel: a tripped breaker often sits in the middle, not clearly OFF. Push it fully off and back on.
Still dead: it’s almost always a loose, burned or failed connection on an outlet upstream of the dead one, on the same circuit. The outlet that looks fine is often the one that failed. Half of an outlet dead and half live usually means it’s wired to a wall switch.
Try first: GFCI resets, then the breaker. Call us if: the outlet is warm, discolored, smells, or a GFCI won’t reset.
Partial power: some of the house is out
Whole house dark: check the neighbors and the Duke Energy outage map before anything else. That’s the utility.
About half the house out, a 240-volt appliance (dryer, range, AC) running weakly or not at all, or lights unusually bright in some rooms and dim in others: one of the two legs feeding the house is lost, or the neutral is loose. It can be on the utility’s side of the meter or ours. Either way it’s hard on electronics and motors.
One room or a few outlets: back to the GFCI and breaker checks above.
Try first: the outage map, then GFCI and breakers. Call us if: it’s half the house or lights are brightening and dimming. Unplug TVs, computers and the fridge until it’s sorted.